Use in an area with adequate ventilation, and always wear proper safety and protective equipment. This product is flammable during dispensing. Do not use near flame or sparks, and do not smoke during use.

  1. Clean and remove grease, dirt and debris from application area.
  2. Use in temperature between 60° F and 95° F. Do not use in temperatures below 40° F.
  3. Shake can vigorously for at least one minute prior to use.
  4. Thread can onto dispensing gun. DO NOT OVERTIGHTEN.
  5. Holding can UPSIDE DOWN, slowly pull the trigger until the foam flows smoothly. NEVER activate the valve with the can right side up, or the propellant will escape.
  6. Fill cavities 50% full.
  7. Tack free time is approximately 10 minutes, and full cure is 24 hours (40% relative humidity and 68° F.)
  8. Paint or cover the foam if it is exposed to sunlight.
  9. When you have completed your application, remove the can from the gun by holding upside down in a trash container. Slowly unscrew the can of foam taking care to keep the valve pointed away from you. Use the Versi-Solv Gun Cleaner to clean the adapter. Thread can of Versi-Solve Gun Cleaner onto the gun. Pull the trigger to flush the cleaner through the gun. Remove can of cleaner. Cured foam cannot be removed with solvents. For foam which has hardened onto the skin, soak affected area with warm, soapy water, then apply petroleum jelly. The foam will wear off in time. The cured foam is not harmful to health.

This page has been visited 12,077 times since July 01st, 2010

ApogeeINVENT Dynamic Marketing Website