Versi-Foam^® Safety

Tax Break

Get up to $1,500 in tax credits by using Spray Foam Insulation!

System 100

The Versi-Foam System 100 Open Cell is a Class I foam with a density of approximately 0.75 pounds per cubic foot.  READ MORE

Hy-Flo Systems

The Versi-Foam Class I foam is also available in constant pressure systems where a consistent spray pattern is needed from start to finish. READ MORE

For proper set-up and use of the Versi-Foam^® Systems, please read our Operators Manual

Medium and Large Kits – System 9, 15, 10, 28, 50, 33, 88, 100, and Hy-Flo 700

Medium and large size spray foam insulation kits in the standard, non-rated foam formula.

• Operator's Manual
• System 15 Video (WMV)
• System 50 Video (WMV)

Small Kit - System I

Smallest size of Versi-Foam^® spray foam insulation products.

• Operators Manual

Versi-Tite^® One Component Sealant

12 oz. and 24 oz. with Straw Dispenser | 24 oz. Refill for Gun

Personal Protective Equipment

Versi-Foam® two-component spray foam systems are professional systems that should be used under proper health and safety conditions. All Versi-Foam® Systems are low-pressure products, with a dispensed pressure of below 250/psi.

The recommended Personal Protective Equipment (PPE) for Versi-Foam® Systems is as follows:

• Chemical resistant safety goggles
• Chemical resistant protective clothing to ensure there is no exposed skin
• Nitrile gloves (provided in all medium and large size Versi-Foam® Systems)
• A NIOSH (National Institute of Safety and Health) approved respirator
  • There are many respirator options and the correct respirator may be determined based on the project conditions (e.g. ventilation) and/or the applicator preference. Several options include:
  • Half-mask respirators with organic vapor cartridges and particulate filters (P100). Half-mask respirators require a fit test and cartridges/filters should be changed in accordance to a regular schedule.
  • Full-mask respirators with organic vapor cartridges and particulate filters. The face-shield protects face and eyes from irritants and contaminants. Full-mask respirators require a fit test and cartridges/filters should be changed in accordance to a regular schedule.
  • Powered Air Purifying Respirator (PAPR) with an organic vapor cartridge. This type of respirator offers breathing comfort from a battery-powered fan which pulls air though filters and circulates air throughout helmet/hood.
  • For more respirator information, please visit www.osha.gov

First Aid for Low-Pressure Spray Foam Systems

The following outlines First Aid measures to be taken in case of an incident:

• For any first aid case, consult a physician.
• Eyes: Flush with water for at least 15 minutes. Seek medical attention.
• Skin: Remove contaminated clothing. Wash skin with plenty of soap and water. Cured foam must be removed mechanically. Seek medical attention if irritation develops or persists.
• Inhalation: Move to fresh air. If breathing is difficult, give oxygen. If breathing has stopped, administer CPR. Seek immediate medical attention.
• Ingestion: Drink large quantities of water. Do not induce vomiting. Contact a physician immediately in any first aid situation. See Material Safety Data Sheet for more information.

For more information about the health and safety considerations when using spray polyurethane foams, visit www.spraypolyurethane.org or refer to the Versi-Foam® Material Safety Data Sheets.