Spray Foam Dispensing Systems Accessories

All VERSI-FOAM® Systems (other than System I) include a spray foam gun/hose assembly, a packet containing ten mixing nozzles, and three fan tips. In the event that the kit was not functioning properly due to too long of time between uses or extreme humidity causing a clog on the "A" component side of the gun, replacement gun and hose assemblies are available for purchase.

All mediums size kits use the 10 foot gun/hose assembly complete with a packet of ten mixing nozzles and three fan tips. Part number G07.5C.

All large size kits use the 15 foot gun/hose assembly complete with a packet of ten mixing nozzles and three fan tips. Part number G15C.

In addition, a 30 foot gun and hose assembly is available and can ONLY be used with the large size kits. Please be aware that the systems are pressurized with sufficient nitrogen to evacuate tanks using the length of hose that is standard equipment (as listed above). Using longer hoses may result in insufficient pressure to completely evacuate the tanks.

All VERSI-FOAM® Systems (other than System I) include ten mixing nozzles. These nozzles snap into the front of the gun, and it is the only place in the system where the two chemicals are mixed together and they actually become foam. It is for this reason that the nozzle must be changed every time dispensing has been stopped for longer than the tack free time. In the majority of our systems, that is 30 to 45 seconds. If your application requires numerous small shots, it may be necessary to purchase extra mixing nozzles. The multipurpose nozzle and the extending mixing nozzle are available for purchase in any quantity.

Each VERSI-FOAM® System (other than System I) includes three fan tips. This is an accessory that is screwed onto the threaded end of the mixing nozzle to produce a fan spray pattern. The pattern is approximately 14" wide when you are standing 18" to 24" from the surface. This accessory will work with all foam formulas.